Re: Hill Top 20 firmware update (and hello!)

Dave Benson

Hi Colin-

Great job on the transatlantic QSOs!  I'm pretty sure I'd put in more effort on the keyer before it became a production item.  I do remember that mode B gave me fits!

73-  Dave, K1SWL

On Sat, Apr 4, 2020 at 11:44 AM Colin Evans M1BUU <colin.evans2@...> wrote:
Yes Bob, it was my first experience with a Nano. I used a cheap clone, it worked fine.
The first HT20 was developed by Dave for his own amusement I believe, without an intention to turn it into a kit. It was simpler to use Arduino and SI5351A modules rather than have to place all the programming interface on the PCB and have to solder the tiny PLL chip.

73, Colin

On Sat, 4 Apr 2020, 13:58 WA1EDJ, <bobc784@...> wrote:
Is the attached photo an early HT20 or ??  I never knew it used a Nano as a controller.  


On Sat, Apr 4, 2020 at 8:46 AM Colin Evans M1BUU <colin.evans2@...> wrote:
Hi to the group members.

I'm Colin, M1BUU, and I've built many QRP transceivers over the years. Several years ago I built an early Hill Top 20. The rig is impressive, however my code sending skills are not! I cut my teeth on KD1JV MTRs and I can send mostly good code with them, however, if I swap to a different kind of rig, I find myself sending garbage. I have used my Hill Top 20 and managed transatlantic QSOs but I do find that I have to argue with the keyer quite a lot (almost certainly a fault with me).

I joined the group to learn more about the rig to find out it little quirks. As we're effectively in lockdown here in England, I'm using my spare time to revisit old projects and do the tweaks that I always intended to do.

I'm thinking about trying to put new firmware on my HT20, I haven't studied the 'production' firmware but I'm sure I'll be able to tweak it to make it work with my rig. I'm hopeful that the keyer timing might work better for me.

73, Colin

Join to automatically receive all group messages.