code will not compile - Hilltopper 20
|
Eric Holzapfel <ewholz@...>
Hello,
I decided I would like to try to progarm the ATMega328p chip with the "standard" hilltopper code posted in the Files section. I have a Arduino Uno board, and a couple of atmega 328 chips. I cannot get the code to compile using the Arduino IDE (ver 1.8.9) or the Atmel Studio 7. I can load a test program in the chip ( a simple "blink" program) just to prove I can talk to the chip, and run a program. The problem seems to be with the si5351 library and the arduino code itself: si5351.init(SI5351_CRYSTAL_LOAD_6PF, 0, 0); //set PLL xtal load
si5351.set_correction(FSCALE); The code snippet above is from the provided code, I see where the class in the si5351.h and the .cpp file have definitions for the methods above. The void set_correction(int32_t, enum si5351_pll_input); seems to call for two variables. the code refers to only one - FSCALE. I must be missing something here - all the different code samples for programming the hilltopper have the same code. Am I missing something in my environment? Is there an updated wire.h or eeprom that I am missing? Any tips will help - I have not tried to use or program the chip that came with hilltopper chip - since I have other chips around. I get the same error with either IDE, Arduino or Atmel studio. Or perhaps I have the incorrect library for the si5351 device (I also have seen an Adafruit_SI5351_library). thanks, eric ewholz1
|
|
|
|
AG1P Ron
I was able to get it to compile using Arduino version 1.8.7 and the Si5351 version Etherkit_Si5351-2.0.1.zip from https://www.arduinolibraries.info/libraries/etherkit-si5351
72 - Ron - AG1P
From: HilltopperKit@4SQRP.groups.io [mailto:HilltopperKit@4SQRP.groups.io] On Behalf Of Eric Holzapfel
Hello, si5351.init(SI5351_CRYSTAL_LOAD_6PF, 0, 0); //set PLL xtal load si5351.set_correction(FSCALE);
|
|
|
|
Eric Holzapfel <ewholz@...>
Hello Ron,
Thanks! I will take a look at the info you provided, and try that. Thanks, will get back if successuful!
|
|
|
|
Charles W. Powell
Yes, Etherkit version 2.0.1 is the one needed. It is *NOT* the latest version.
toggle quoted messageShow quoted text
72, Chas - NK8O
|
|
|
|
Eric Holzapfel <ewholz@...>
Now THAT makes sense!! Thanks Guys!! Shame on me for not reading Ron's post MORE carefully!
Eric
|
|
|
|
Eric Holzapfel <ewholz@...>
All is well, bad Arduino , got new Arduino, and can program no problem
|
|
|
|
Charles W. Powell
Good news. Glad you found the problem.
toggle quoted messageShow quoted text
72, Chas - NK8O
|
|
|