even with my hearing aids would still like more audio . any one got a mod yet please /???

Hi folks, first post here in the forums. I stumbled on a schematic of the modifications to the Murania AM radio elsewhere on the internet, and dressed it up a bit... I figured that I'd post it here :)

Update re tuning with 52 turns, 880 comes in when the dial is on 9, so it is probably not yet ideal and might need a couple or a few more turns to be spot on. (I get pretty much just one local station

fwiw I have tried a variety of small speakers, 4 8 16 25 32 and 45 ohms, the impedance does not have a noticeable significant effect to my surprise, larger ones seem to make more sound than smaller

Does the volume vary with the speaker impedance? The ones in the photo section seem to be 8 ohms, mine is 16 ohms. Would 4, 8, or 16 be best? Or does it matter?

Hi Matt, You do have to mess with that little loop of wire “L2”, just in case you haven’t. It might make a significant difference if you get it just right. fwiw jer aa1of

Using the wire that comes with the kit I reduced mine to 52 turns and the dial seems to be accurate, at least at with the local 1400 kHz station. Fwiw my AADE meter measured ~210uH. I changed Q1 to a

Assembly's not yet complete but wanted to share some numbers from the coil wind. I decided to include the coil mod/C8 delete from the start. The inexpensive M4070 LCR meter's been reasonably

After some reflection, it has occurred to me that when building a radio with my grandson, it may well be that limited volume may well be a positive feature for his mother, my daughter...!

I’m not skilled enough at the component level to find the solution but I have to believe that someone on here will have the answer. As it was mentioned above, the mods made a very big difference in

I too would like to see better audio out of mine. Holding it up to the side of my head to hear it is the only reason it sits on my shelf unused..

Is there a better choice for Q1?

I think that after the mods the performance clarity and selectivity seemed better but the volume a bit less and have wondered the same thing.

Curt- Anytime there's a boatload of audio gain, there's always the possible of feedback causing a squeal or motorboating. Often with an add-on amplifier, it may be necessary to run that on a

Has anyone made any modifications to make the audio louder? I'm not smart enough to do it but it would be interesting if someone could come up with a small amplifier circuit that could be put between

My experience: The directions on trimming the extra variable cap straps could be clearer. On the photos page there are 3 pictures showing the variable cap. The first shows it oriented one way and the

I found the problem. The solder point of wire going from R3 to C7 cap was loose but not visible to the naked eye. Re-soldered that connection and problem solved. Thanks for the help. Tommy K4VOZ

Hi Tommy...Wow...There's not much that can go wrong with the circuit...If you don't even have power to the LED, I would start at the battery and check the voltage through R5...That's a good place to

Hi All, My Murania radio does not power on anymore, no LED or sound comes up. I finished building the Murania kit and was working fine, I proceeded to do WB2LHP mods and the radio was even better.

In case you missed it, here is a link to Dave's excellent Murania You Tube video