Philip Karras <ke3fl@...>
OK, the radio is all together but does not work at all well.
I live 20 miles from Baltimore, Washington DC and 15 miles from Frederick Maryland with numerous AM stations still active and yet I hear nothing.
The LED does get dimmer near the higher end of the band and at full volume I can hear squeals but no stations are heard.
There is static and if I place it near a switching power supply, wall wart, I can hear the characteristic high pitched AM noise. So it does well hearing digital AM noise and probably lightning as well but as a radio it is not working.
Any ideas as to what I can TRY? I think it is obvious that the audio section works also the tuner works at least to some degree but the AM decoding doesn't seem to be working or my tuner is way off the mark.
I have a frequency generator which goes up to 1 MHz, but I could use a square wave & get all the odd harmonics, I did that once with an AM transmitter I made, tubes, when I chopped off part of the sine wave (over driven) and on our big receiver I was transmitting from the fundamental all the way up as far as the receiver would go. So here's what I've tried with the generator so far:
With my scope, an Alinco DJ-X10 wide band receiver and the Muranai:
601.8 X-10 = quiet at 601.8 kHz Mur ~not found
702.2 X-10 = quiet at 702.2 kHz * Mur between 5 - 6
900.2 X-10 = quiet at 900.2 kHz * Mur ~ 7
1044.0 X10 = quiet at 1044. kHz * Mur between 8 - 9
The X-10 also has a band scope and it showed a bad of frequencies being received centered around the frequency tuned in. All was quiet since the signal was not being modulated.
Tnx es 73 de KE3FL,