Re: QRPOmeter

Rich Fowler <k8meg@...>

Hi Bobby,

For the first step, reheat and apply solder to the 8 100 ohm 2W resistors. Top and bottom. If the solder joint look questionable on the PCB anywhere else, reheat and apply a fresh bead of solder on all joints. Apply only enough heat and solder to cause the solder to flow. If this doesn't work, I have plan 2. If you reheat the switch contacts, tilt the board so solder doesn't run into the switches or you'll have a bigger headache to deal with!

Rich K8MEG

Join to automatically receive all group messages.