ANOTHER GREAT NET TONIGHT, AND MANY GOOD IDEAS TONIGHT'S CHECK-IN'S NK80 CHARLES W4DNQ RON N0S0 MIKE N0MII JEFF KD2KUB ANDRIY WG5F ED W0MFQ TOM K0VAB VIC N0TGR DICK K5RLN BOB

Thanks Paul Glad you guys got together! 73 Johnny AC0BQ -- Check out the 4SQRP website at 4sqrp.com

It's a 1000 mile drive for me. I should have stayed in Rolla! Virus-free. www.avast.com

I have looked at several ways to attend OzarkCon for a couple of years now. Got excited last year when Flights were going to begin from Florida to Branson....... turned out it was seasonal and summer

Random thoughts that I have no ability at this time to help make reality. With the right IT wiz you can get some pretty inexpensive IP cameras with sound at a reasonable cost and have one or two

Does anyone have a copy of the Murania assembly manual they can email me? The links on the 4SQRP Murania page don't seem to be working. -- Tom Sevart N2UHC St. Paul, KS

Manual received, thanks! -- Tom Sevart N2UHC St. Paul, KS

Please see attached. ~Josh W0ODJ

I was able to download it for you..... sometimes things just don't wotk. John KK4ITX Click Here for Zephyrhills Area Amateur Radio Club Many of life's failures are people who did not realize how close

Hilltoppers 40 not keying at startup nor keying at any other time any troubleshooting suggestions thanks

Check the push button switch to make sure it’s the right sex

I have on my very cluttered bench an extra EZKeyer III.  I have no idea how I wound up with it. It has a small diameter aluminum speed knob and is minus one rubber foot.  Sorta resembles the old

Terry, That is what happens when “Old” hams stay up past 10 PM. Or inhaling too much solder smoke. Along with plugging in power supplies backwards and letting smoke out. I frequently purchase

Terry- What- if anything- does work? Morse readout on power up? If the Function switch polarity is OK (normally open), you might check this: Is power getting to the ATmega328? Pin 7 should be

I have a Hilltopper 20, and it's being odd. It powers up and gives me the 60r0 just fine. I transmit and it it's transmitting on 14062. So I followed the alignment procedure in the docs, moved the

Brian- If I read that right, are you adding the CAL jumper *after* power is applied? That doesn't work- the firmware looks for the jumper only at power-up. It should work properly if you install

Thanks Dave, I was installing the jumper....and then powering up. Will try it again tonight, and will make a note of each step. de KB9BVN -- 73 de KB9BVN Brian Murrey

Brian- OK- that's good. When you power up with the jumper already installed, you'll get 5 seconds of full power out. You can see the frequency displayed on a counter or hear the pitch on another rig.

Dave, GREAT! Thanks for this. I was powering up with CAL jumper in place...but not powering down between attempts. When I restart the CAL procedure, will I HEAR 60r0 still but see the freq has

Hi Dave, indeed. I have a bunch of unbuilt kits peeking at me late at night from their storage box :o) 72 WAØITPI love this radio stuff.www.wa0itp.comwww.4sqrp.com On