The kit comes with 12 inches of 22 AWG stranded and 6 feet of 22 AWG magnet wire, per the bill of materials.

This is cross-posted in a few IO groups, just FYI. I have a virgin Wilderness 40A Rev C and want to start sea trials with another 40A. Whether it is a qrp-tech 40A, a Norcal version, or a Wilderness

Reminder: Wednesday Evening 40 and 80 meter Nets When: Wednesday, 16 October 2019, 8:00pm to 9:00pm, (GMT-05:00) America/Chicago Where:40 and 80 Meters View Event Organizer:

Hi I have one more question to ask and that is what gauge wire is used for the toroids T50-2 and T50-6. Kit Nouveau 75, is it #22 gauge magnet wire? thanks, terry

should I rewind them

It should be flatter than this, but given the tolerance errors that can creep in to hand-wound toroids, it's probably not too abnormal.

Hi, joe I haverecently built the nouveau 75 and I have installed the new board you sent me.it seems like it needs a fine tune adjustment but that's what I am writingabout it's that when I use the

Hi Terry, I don't know anything about this kit or its adjustments. I was not the one who sent you the board. I think you need to contact Dave Cripe, NM0S who is the designer of the nouveau 75. Wish

This is a 75M transceiver. You should not be transmitting at 8 or 9 MHz. 73 Dave NM0S

Hi, joe I have recently built the nouveau 75 and I have installed the new board you sent me. it seems like it needs a fine tune adjustment but that's what I am writing about it's that when I use the

I was waiting for David or someone to reply but I can confirm that the silk-screen is incorrect.   If you look at page 5 of the assembly manual presently on the website it now says that the flat

There are a couple of construction details mentioned in the assembly manual that need repeating here. 1. The main PCB transistor Q2 must be installed with its large flat face oriented toward the

I always believe the schematic first. Identify the drain lead on Q2 (from data sheet). Then, using an ohmmeter, identify the pad on the board which is connected to C9. The drain lead

Nothing yet. The picture clearly shows the large flat side to the left, matching the marking on the board. However the instructions explicitly say orient it to the right, opposite of the marking on

Has anyone received an answer about the Nouveau 75 Q2's drawing being mis-oriented yet? Looking at the schematic it certainly seems that it is.

The Bayou Jumper has been sold. Thanks 73 Bobby

Reminder: Wednesday Evening 40 and 80 meter Nets When: Wednesday, 16 October 2019, 8:00pm to 9:00pm, (GMT-05:00) America/Chicago Where:40 and 80 Meters View Event Organizer:

do not need very much sensitivity for the am radios. I think what you will find out, you will need an extremely strong am signal in order for them to hear you. They may be a 20 db over 9 to you,

That still sounds a little weak to me, although I'm not an AM expert. A -73 dBm signal is S-9, so you'd think it would be pretty solid. No doubt the % modulation of the signal would come into play.

GM. I am trying to clean up the shack a little bit so I want to Sale a couple of rigs that I never use much anymore. First I have a Bayou Jumper with the newer green faceplate. It also has the Super