Absolutely we should plan on using the club call. Charles

Yes, that part could probably be 3D printed. I would be happy to do so if someone could provide precise dimensions. It gets difficult visualizing the possible combinations without actually

Kenneth, try Google! I found this ad for 2 caps with pulleys. Also looked at Gilbert erector set parts and pulleys. Found lots of pulleys, wheels, and gears for shafts. If all else fails, and you

OK Johnny, Ill drag one or both sons along. They worked in Weston years ago and LIVED at that park. They spent a year rebuilding a stone church. happy Holidays my Brother. de Paul Sent from Outlook

COME ON UP PAUL The more the better! FYI We could run with the 4 sqrp club call?

This sounds cool, maybe i can get Richard and Les to bring me up. Toodles would not want to camp but me and the boys would. have KX2 and wire I want to travel de Paul N0NBD Sent from Outlook

Gm Terry and the Group Sounds like a plan! We will need two adjoining camp sites so we can stretch out our antennas. I remember some that were on top of the ridge that has really nice

Count me in Chas, and thanking you for planning it this far ahead. I operated there once with Johnny and Bert and there are some very good sites. I'll use my ATS4

Greetings, Could this part be 3D printed? I do not have a printer, but always thought if some had a service to print parts they could pay for the printer in a short amount of time. This would be a

Greetings folks I am updating an old Meissner morale Rx that has a teeny cap drive pulley ... about 1.5 inch diameter. Ok for bc but makes tuning sw very touchy. I want to replace that with a three

Hi John, I’m sure this bundle is already sold, if not I will take them. Bart W0IIT

:) I bet that is a really good book ! I would really like to read that ! I have always had a fascination with crystals ! Lots of crystals have the the month and year they were made ! I have some that

I just cut the pins on the chip I am removing then clean the holes. I them use a solder sucker and de-solder braid. Bob Macklin K5MYJ Seattle, Wa. "Real Radios Glow In The Dark"

You definitely need the full size solder sucker. Those little ones just don't do the job. 72 Duane, KE0IUV Sent from TypeApp

If you meant the solder sucker, Brian, the one I recommended works well enough to successfully remove 14 pin ICs ( with some final help from a heat gun) and leave the holes clean when you put the

There has been some discussion regarding a Field Day effort for the 4-State club, such as it is. So far, the only standing suggestion is for Weston Bend State Park, just across the river for

A really interesting book, about the challenges Uncle Sam faced as he ramped up crystal production in the 40's, is Crystal Clear, The struggle for reliable communications technology in World War

Hello again :) I have a bunch Like 10 pounds worth of ft-171-b crystals ! Brand new Uncle Sam really liked crystals ! I would like to know how much uncle Sam spent :) Likely all ft 242 and the whole

What I would like to know is how Leo Meyerson was able to turn a drill press into a lapping machine. As mentioned keeping the sides flat and parallel are key. I could never do it. Could

I hope its ok that I post this here. I have restocked my version of the CW Zero beat kits. They can be purchased here: CW Zero Beat 73 Happy Holidays! -- David N8DAH Kit-Projects.com Shop